Datasheet

305
SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
Figure 27-6. Receiver Ready
27.5.2.4 Receiver Overrun
If DBGU_RHR has not been read by the software (or the Peripheral Data Controller) since the last transfer, the
RXRDY bit is still set and a new character is received, the OVRE status bit in DBGU_SR is set. OVRE is cleared
when the software writes the control register DBGU_CR with the bit RSTSTA (Reset Status) at 1.
Figure 27-7. Receiver Overrun
27.5.2.5 Parity Error
Each time a character is received, the receiver calculates the parity of the received data bits, in accordance with
the field PAR in DBGU_MR. It then compares the result with the received parity bit. If different, the parity error bit
PARE in DBGU_SR is set at the same time the RXRDY is set. The parity bit is cleared when the control register
DBGU_CR is written with the bit RSTSTA (Reset Status) at 1. If a new character is received before the reset status
command is written, the PARE bit remains at 1.
Figure 27-8. Parity Error
27.5.2.6 Receiver Framing Error
When a start bit is detected, it generates a character reception when all the data bits have been sampled. The stop
bit is also sampled and when it is detected at 0, the FRAME (Framing Error) bit in DBGU_SR is set at the same
time the RXRDY bit is set. The bit FRAME remains high until the control register DBGU_CR is written with the bit
RSTSTA at 1.
Figure 27-9. Receiver Framing Error
D0 D1 D2 D3 D4 D5 D6 D7 PS
S
D0 D1 D2 D3 D4 D5 D6 D7 P
DRXD
Read DBGU_RHR
RXRDY
D0 D1 D2 D3 D4 D5 D6 D7 PS
S
D0 D1 D2 D3 D4 D5 D6 D7 P
DRXD
RSTSTA
RXRDY
OVRE
stop
stop
stop
D0 D1 D2 D3 D4 D5 D6 D7 PS
DRXD
RSTSTA
RXRDY
PARE
Wrong Parity Bit
D0 D1 D2 D3 D4 D5 D6 D7 PS
DRXD
RSTSTA
RXRDY
FRAME
Stop Bit
Detected at 0
stop