Datasheet

179
SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
20.11.3 Ready Mode
In Ready mode (EXNW_MODE = 11), the SMC behaves differently. Normally, the SMC begins the access by
down counting the setup and pulse counters of the read/write controlling signal. In the last cycle of the pulse
phase, the resynchronized NWAIT signal is examined.
If asserted, the SMC suspends the access as shown in Figure 20-28 and Figure 20-29. After deassertion, the
access is completed: the hold step of the access is performed.
This mode must be selected when the external device uses deassertion of the NWAIT signal to indicate its ability
to complete the read or write operation.
If the NWAIT signal is deasserted before the end of the pulse, or asserted after the end of the pulse of the
controlling read/write signal, it has no impact on the access length as shown in Figure 20-29.
Figure 20-28. NWAIT Assertion in Write Access: Ready Mode (EXNW_MODE = 11)
EXNW_MODE = 11 (Ready mode)
WRITE_MODE = 1 (NWE_controlled)
NWE_PULSE = 5
NCS_WR_PULSE = 7
A
[25:2]
MCK
NWE
NCS
432 1 000
456321110
Write cycle
D[31:0]
NWAIT
internally synchronized
NWAIT signal
Wait STATE
NBS0, NBS1,
NBS2, NBS3,
A0,A1