Datasheet
Table Of Contents
- 1. Description
- 2. About Code Examples
- 3. AVR CPU Core
- 4. Memories
- 5. System Clock
- 6. Power Management and Sleep Modes
- 7. System Control and Reset
- 8. Interrupts
- 9. I/O-Ports
- 10. External Interrupts
- 11. Timer/Counter3/1/0 Prescalers
- 12. 8-bit Timer/Counter0 with PWM
- 13. 16-bit Timer/Counter (Timer/Counter1 and Timer/Counter3)
- 14. 8-bit Timer/Counter2 with PWM and Asynchronous Operation
- 14.1 Features
- 14.2 Overview
- 14.3 Timer/Counter Clock Sources
- 14.4 Counter Unit
- 14.5 Output Compare Unit
- 14.6 Compare Match Output Unit
- 14.7 Modes of Operation
- 14.8 Timer/Counter Timing Diagrams
- 14.9 8-bit Timer/Counter Register Description
- 14.10 Asynchronous operation of the Timer/Counter2
- 14.11 Timer/Counter2 Prescaler
- 15. Output Compare Modulator - OCM
- 16. Serial Peripheral Interface - SPI
- 17. USART (USART0 and USART1)
- 17.1 Features
- 17.2 Overview
- 17.3 Dual USART
- 17.4 Clock Generation
- 17.5 Serial Frame
- 17.6 USART Initialization
- 17.7 Data Transmission - USART Transmitter
- 17.8 Data Reception - USART Receiver
- 17.9 Asynchronous Data Reception
- 17.10 Multi-processor Communication Mode
- 17.11 USART Register Description
- 17.12 Examples of Baud Rate Setting
- 18. Two-wire Serial Interface
- 19. Controller Area Network - CAN
- 20. Analog Comparator
- 21. Analog to Digital Converter - ADC
- 22. JTAG Interface and On-chip Debug System
- 23. Boundary-scan IEEE 1149.1 (JTAG)
- 24. Boot Loader Support - Read-While-Write Self-Programming
- 25. Memory Programming
- 26. Electrical Characteristics (1)
- 26.1 Absolute Maximum Ratings*
- 26.2 DC Characteristics
- 26.3 External Clock Drive Characteristics
- 26.4 Maximum Speed vs. VCC
- 26.5 Two-wire Serial Interface Characteristics
- 26.6 SPI Timing Characteristics
- 26.7 CAN Physical Layer Characteristics
- 26.8 ADC Characteristics
- 26.9 External Data Memory Characteristics
- 26.10 Parallel Programming Characteristics
- 27. Decoupling Capacitors
- 28. AT90CAN32/64/128 Typical Characteristics
- 28.1 Active Supply Current
- 28.2 Idle Supply Current
- 28.3 Power-down Supply Current
- 28.4 Power-save Supply Current
- 28.5 Standby Supply Current
- 28.6 Pin Pull-up
- 28.7 Pin Driver Strength
- 28.8 Pin Thresholds and Hysteresis
- 28.9 BOD Thresholds and Analog Comparator Offset
- 28.10 Internal Oscillator Speed
- 28.11 Current Consumption of Peripheral Units
- 28.12 Current Consumption in Reset and Reset Pulse Width
- 29. Register Summary
- 30. Instruction Set Summary
- 31. Ordering Information
- 32. Packaging Information
- 33. Errata
- 34. Datasheet Revision History for AT90CAN32/64/128
- 34.1 Changes from 7679G - 03/08 to 7679H - 08/08
- 34.2 Changes from 7679F - 11/07 to 7679G - 03/08
- 34.3 Changes from 7679E - 07/07 to 7679F - 11/07
- 34.4 Changes from 7679D - 02/07 to 7679E - 07/07
- 34.5 Changes from 7679C - 01/07 to 7679D - 02/07
- 34.6 Changes from 7679B - 11/06 to 7679C - 01/07
- 34.7 Changes from 7679A - 10/06 to 7679B - 11/06
- 34.8 Document Creation

422
7679H–CAN–08/08
AT90CAN32/64/128
5.9 Timer/Counter2 Oscillator .................................................................................43
5.10 System Clock Prescaler ....................................................................................44
6 Power Management and Sleep Modes ................................................. 46
6.1 Idle Mode ..........................................................................................................47
6.2 ADC Noise Reduction Mode .............................................................................47
6.3 Power-down Mode ............................................................................................47
6.4 Power-save Mode .............................................................................................47
6.5 Standby Mode ...................................................................................................48
6.6 Minimizing Power Consumption .......................................................................48
7 System Control and Reset .................................................................... 51
7.1 Reset ................................................................................................................51
7.2 Internal Voltage Reference ...............................................................................56
7.3 Watchdog Timer ...............................................................................................57
7.4 Timed Sequences for Changing the Configuration of the Watchdog Timer .....59
8 Interrupts ................................................................................................ 60
8.1 Interrupt Vectors in AT90CAN32/64/128 ..........................................................60
8.2 Moving Interrupts Between Application and Boot Space ..................................64
9 I/O-Ports .................................................................................................. 66
9.1 Introduction .......................................................................................................66
9.2 Ports as General Digital I/O ..............................................................................67
9.3 Alternate Port Functions ...................................................................................71
9.4 Register Description for I/O-Ports .....................................................................89
10 External Interrupts ................................................................................. 93
10.1 External Interrupt Register Description .............................................................93
11 Timer/Counter3/1/0 Prescalers ............................................................. 96
11.1 Overview ...........................................................................................................96
11.2 Timer/Counter0/1/3 Prescalers Register Description .......................................98
12 8-bit Timer/Counter0 with PWM ............................................................ 99
12.1 Features ............................................................................................................99
12.2 Overview ...........................................................................................................99
12.3 Timer/Counter Clock Sources .........................................................................100
12.4 Counter Unit ....................................................................................................100
12.5 Output Compare Unit ......................................................................................101
12.6 Compare Match Output Unit ...........................................................................103