Datasheet
870
32117D–AVR-01/12
AT32UC3C
32. USB Interface (USBC)
Rev: 2.1.0.16
32.1 Features
• Compatible with the USB 2.0 specification
• Supports full (12Mbit/s) and low (1.5Mbit/s) speed communication
• Supports Embedded Host
• 7 physical pipes/endpoints in ping-pong mode
• Flexible pipe/endpoint configuration and reallocation of data buffers in embedded RAM
• Supports an infinite number of virtual pipes (alternate pipe)
• Up to two memory banks per pipe/endpoint
• Built-in DMA with multi-packet support through ping-pong mode
• On-chip transceivers with built-in pull-ups and pull-downs
• On-chip Embedded Host pad with a VBUS analog comparator
32.2 Overview
The Universal Serial Bus interface (USBC) module complies with the Universal Serial Bus (USB)
2.0 specification, .
Each pipe/endpoint can be configured into one of several transfer types. It can be associated
with one or more memory banks (located inside the embedded system or CPU RAM) used to
store the current data payload. If two banks are used (“ping-pong” mode), then one bank is read
or written by the CPU (or any other HSB master) while the other is read or written by the USBC
core.
Table 32-1 describes the hardware configuration of the USBC module.
32.3 Block Diagram
The USBC interfaces a USB link with a data flow stored in the embedded ram (CPU or HSB).
The USBC requires a 48MHz ± 0.25% reference clock, which is the USB generic clock. For
more details see ”Clocks” on page 873. The 48MHz clock is used to generate either a 12MHz
full-speed or a 1.5MHz low-speed bit clock from the received USB differential data, and to trans-
mit data according to full- or low-speed USB device tolerances. Clock recovery is achieved by a
digital phase-locked loop (a DPLL, not represented) in the USBC module, which complies with
the USB jitter specifications.
Table 32-1. Description of USB pipes/endpoints
pipe/endpoint Mnemonic Max. size
Number of
available banks Type
0 PEP0 1023 bytes 1 Control/Isochronous/Bulk/Interrupt
1 PEP1 1023 bytes 2 Control/Isochronous/Bulk/Interrupt
2 PEP2 1023 bytes 2 Control/Isochronous/Bulk/Interrupt
... ... ... ... ...
6 PEP6 1023 bytes 2 Control/Isochronous/Bulk/Interrupt