Datasheet

595
32117D–AVR-01/12
AT32UC3C
25.6.6 RS485 Mode
The USART features the RS485 mode to enable line driver control. While operating in RS485
mode, the USART behaves as though in asynchronous or synchronous mode and configuration
of all the parameters is possible. The difference is that the RTS pin is driven high when the
transmitter is operating. The behavior of the RTS pin is controlled by the TXEMPTY bit. A typical
connection of the USART to a RS485 bus is shown in Figure 25-35.
Figure 25-35. Typical Connection to a RS485 Bus
The USART is set in RS485 mode by programming the MODE field in the Mode Register (MR)
to the value 0x1.
The RTS pin is at a level inverse to the TXEMPTY bit. Significantly, the RTS pin remains high
when a timeguard is programmed so that the line can remain driven after the last character com-
pletion. Figure 25-36 gives an example of the RTS waveform during a character transmission
when the timeguard is enabled.
Figure 25-36. Example of RTS Drive with Timeguard
USART
RTS
TXD
RXD
Differential
Bus
D0 D1 D2 D3 D4 D5 D6 D7
TXD
Start
Bit
Parity
Bit
Stop
Bit
Baud Rate
Clock
TG = 4
Write
THR
TXRDY
TXEMPTY
RTS