Datasheet

14.3.2.1 Simplified EU Declaration of Conformity

Hereby, Microchip Technology Inc. declares that the radio equipment type ATWINC15x0-MR210xB is in

compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity for this product is available at http://www.microchip.com/

design-centers/wireless-connectivity/.

14.3.3 Helpful Websites

A document that can be used as a starting point in understanding the use of Short Range Devices (SRD)

in Europe is the European Radio Communications Committee (ERC) Recommendation 70-03 E, which

can be downloaded from the European Communications Committee (ECC) at: http://www.ecodocdb.dk/.

Additional helpful web sites are:

• Radio Equipment Directive (2014/53/EU):

https://ec.europa.eu/growth/single-market/european-standards/harmonised-standards/red_en

• European Conference of Postal and Telecommunications Administrations (CEPT):

http://www.cept.org

• European Telecommunications Standards Institute (ETSI):

http://www.etsi.org

• The Radio Equipment Directive Compliance Association (REDCA):

http://www.redca.eu/

14.4 Japan

The ATWINC15x0-MR210PB module has received type certification and is labeled with its own technical

conformity mark and certification number as required to conform to the technical standards regulated by

the Ministry of Internal Affairs and Communications (MIC) of Japan pursuant to the Radio Act of Japan.

Integration of this module into a final product does not require additional radio certification provided

installation instructions are followed and no modifications of the module are allowed. Additional testing

may be required:

• If the host product is subject to electrical appliance safety (for example, powered from an AC

mains), the host product may require Product Safety Electrical Appliance and Material (PSE)

testing. The integrator should contact their conformance laboratory to determine if this testing is

required

• There is a voluntary Electromagnetic Compatibility (EMC) test for the host product administered by

VCCI: http://www.vcci.jp/vcci_e/index.html

14.4.1 Labeling and User Information Requirements

The label on the final product which contains the ATWINC15x0-MR210PB module must follow Japan

marking requirements. The integrator of the module should refer to the labeling requirements for Japan

available at the Ministry of Internal Affairs and Communications (MIC) website.

For the ATWINC15x0-MR210PB module, due to a limited module size, the technical conformity logo and

ID is displayed in the data sheet and/or packaging and cannot be displayed on the module label. The final

product in which this module is being used must have a label referring to the type certified module inside:

ATWINC15x0

Regulatory Approval

Datasheet

DS70005304C-page 47