Datasheet

This radio transmitter (identify the device by certification number, or model number if Category

II) has been approved by Industry Canada to operate with the antenna types listed below with the

maximum permissible gain and required antenna impedance for each antenna type indicated.

Antenna types not included in this list, having a gain greater than the maximum gain indicated

for that type, are strictly prohibited for use with this device.

Le présent émetteur radio (identifier le dispositif par son numéro de certification) a été approuvé

par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci‑dessous et ayant

un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est

supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.

14.2.3 RF Exposure

All transmitters regulated by Innovation, Science and Economic Development Canada (ISED) must

comply with RF exposure requirements listed in RSS-102 - Radio Frequency (RF) Exposure Compliance

of Radiocommunication Apparatus (All Frequency Bands).

This transmitter is restricted for use with a specific antenna tested in this application for certification, and

must not be co-located or operating in conjunction with any other antenna or transmitters within a host

device, except in accordance with Canada multi-transmitter product procedures.

The installation of the transmitter must ensure that the antenna has a separation distance of at least 6.5

cm from all persons or compliance must be demonstrated according to the ISED SAR procedures.

14.2.4 Helpful Web Sites

Innovation, Science and Economic Development Canada (ISED): http://www.ic.gc.ca/

14.3 Europe

The ATWINC15x0-MR210xB module is a Radio Equipment Directive (RED) assessed radio module that

is CE marked and has been manufactured and tested with the intention of being integrated into a final

product.

The ATWINC15x0-MR210xB module has been tested to RED 2014/53/EU Essential Requirements for

Health and Safety (Article (3.1(a)), Electromagnetic Compatibility (EMC) (Article 3.1(b)), and Radio

(Article 3.2), which is summarized in the following European Compliance Testing table.

The ETSI provides guidance on modular devices in the “Guide to the application of harmonised standards

covering articles 3.1b and 3.2 of the RED 2014/53/EU (RED) to multi-radio and combined radio and non-

radio equipment” document available at http://www.etsi.org/deliver/etsi_eg/203300_203399/20

3367/01.01.01_60/eg_203367v010101p.pdf.

Note: To maintain conformance to the testing listed in the following European Compliance Testing table

the module shall be installed in accordance with the installation instructions in this data sheet and shall

not be modified. When integrating a radio module into a completed product, the integrator becomes the

manufacturer of the final product and is therefore responsible for demonstrating compliance of the final

product with the essential requirements against the RED.

14.3.1 Labeling and User Information Requirements

The label on the final product that contains the ATWINC15x0-MR210xB module must follow CE marking

requirements.

ATWINC15x0

Regulatory Approval

Datasheet

DS70005304C-page 45