Datasheet

14.1 United States

The ATWINC1500-MR210PB, ATWINC1510-MR210PB, ATWINC1500-MR210UB, and ATWINC1510-

MR210UB modules have received Federal Communications Commission (FCC) CFR47

Telecommunications, Part 15 Subpart C “Intentional Radiators” single-modular approval in accordance

with Part 15.212 Modular Transmitter approval. Single-modular transmitter approval is defined as a

complete RF transmission sub-assembly, designed to be incorporated into another device, that must

demonstrate compliance with FCC rules and policies independent of any host. A transmitter with a

modular grant can be installed in different end-use products (referred to as a host, host product, or host

device) by the grantee or other equipment manufacturer, then the host product may not require additional

testing or equipment authorization for the transmitter function provided by that specific module or limited

module device.

The user must comply with all of the instructions provided by the Grantee, which indicate installation

and/or operating conditions necessary for compliance.

A host product itself is required to comply with all other applicable FCC equipment authorization

regulations, requirements, and equipment functions that are not associated with the transmitter module

portion. For example, compliance must be demonstrated: to regulations for other transmitter components

within a host product; to requirements for unintentional radiators (Part 15 Subpart B), such as digital

devices, computer peripherals, radio receivers, etc.; and to additional authorization requirements for the

non-transmitter functions on the transmitter module (i.e., Suppliers Declaration of Conformity (SDoC) or

certification) as appropriate (e.g., Bluetooth and Wi-Fi transmitter modules may also contain digital logic

functions).

14.1.1 Labeling And User Information Requirements

The ATWINC1500-MR210PB, ATWINC1510-MR210PB, ATWINC1500-MR210UB, and ATWINC1510-

MR210UB modules have been labeled with its own FCC ID number, and if the FCC ID is not visible when

the module is installed inside another device, then the outside of the finished product into which the

module is installed must display a label referring to the enclosed module. This exterior label should use

the following wording:

For the ATWINC1500-MR210PB:

Contains Transmitter Module FCC ID: 2ADHKATWINC1500

Contains FCC ID: 2ADHKATWINC1500

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

For the ATWINC1510-MR210PB:

ATWINC15x0

Regulatory Approval

Datasheet

DS70005304C-page 41