Datasheet

1.1.4.1 Battery Holder
The AAx1 battery holder, shown in the following image, is required to hold the battery. This holder can be
found on the website.
Figure 1-4. Battery Holder
A 3 pin wire cable male connector with pitch 2.54 mm is required for the battery holder to connect to the
Wi-Fi Smart Device Enablement Kit.
Build the battery holder with connector, as shown in the following image.
ATWINC15x0 Smart Device Kit
Overview
© 2019 Microchip Technology Inc.
User Guide
DS50002880A-page 7