Datasheet

5. Follow the instructions, and plug in USB power to the USB port or use a lithium battery to provide

power. For power supply settings, see 1.1.4 Power Supply.

6. Connect J8 jumper (pin 2 and pin 3) to switch on the board as shown in the following image.

7. Hold and press SW3 key for 5 seconds. LD2 blinks red as the board enters to the Network

Provisioning mode. LD2 blinks red for every 0.5 sec.

8. Tap Network Provisioning on the mobile application. The following screen is displayed.

9. Following the instruction in the UI, go to iOS device setting page and select Wi-Fi Setting.

ATWINC15x0 Smart Device Kit

Getting Started

User Guide

DS50002880A-page 24