Datasheet

24AA16/24LC16B
DS21703J-page 2 © 2009 Microchip Technology Inc.
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings
(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. V
SS ......................................................................................................... -0.3V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
TABLE 1-1: DC CHARACTERISTICS
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to
the device. This is a stress rating only and functional operation of the device at those or any other conditions
above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
DC CHARACTERISTICS
Industrial (I): TA = -40°C to +85°C, VCC = +1.7V to +5.5V
Automotive (E): T
A = -40°C to +125°C, VCC = +2.5V to +5.5V
Param.
No.
Symbol Characteristic Min. Typ. Max. Units Conditions
D1 V
IH WP, SCL and SDA pins — ————
D2 — High-level input voltage 0.7 V
CC ——V—
D3 VIL Low-level input voltage — — 0.3 VCC V—
D4 VHYS Hysteresis of Schmitt
Trigger inputs
.05 VCC ——V(Note 1)
D5 V
OL Low-level output voltage — — 0.40 V IOL = 3.0 mA, VCC = 2.5V
D6 ILI Input leakage current ——±1μAVIN = VSS or VCC
D7 ILO Output leakage current ——±1μAVOUT = VSS or VCC
D8 CIN,
C
OUT
Pin capacitance
(all inputs/outputs)
——10pFVCC = 5.0V (Note 1)
T
A = 25°C, FCLK = 1 MHz
D9 I
CC write Operating current —— 3mAVCC = 5.5V, SCL = 400 kHz
D10 ICC read — 0.01 1 mA —
D11 ICCS Standby current —
—
0.3
.01
1
5
μA
μA
Industrial
Automotive
SDA = SCL = V
CC
WP = VSS
Note 1: This parameter is periodically sampled and not 100% tested.
2: Typical measurements taken at room temperature.