Datasheet

24C02C
DS21202J-page 2 © 2008 Microchip Technology Inc.
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings
(†)
VCC.............................................................................................................................................................................7.0V
All inputs and outputs w.r.t. V
SS ......................................................................................................... -0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4kV
TABLE 1-1: DC CHARACTERISTICS
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at these or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to Absolute Maximum Rating
conditions for extended periods may affect device reliability.
DC CHARACTERISTICS
Electrical Characteristics:
Industrial (I): VCC = +4.5V to 5.5V TA = -40°C to +85°C
Automotive (E): V
CC = +4.5V to 5.5V TA = -40°C to +125°C
Param.
No.
Sym. Characteristic Min. Max. Units Conditions
D1 — A0, A1, A2, SCL, SDA
and WP pins:
————
D2 V
IH High-level input voltage 0.7 VCC —V—
D3 V
IL Low-level input voltage — 0.3 VCC V—
D4 VHYS Hysteresis of Schmitt
Trigger inputs
(SDA, SCL pins)
0.05 VCC —V(Note)
D5 VOL Low-level output voltage — 0.40 V IOL = 3.0 ma @ VCC = 4.5V
D6 ILI Input leakage current — ±1 μAVIN = VSS or VCC, WP = VSS
D7 ILO Output leakage current — ±1 μAVOUT = VSS or VCC
D8 CIN,
C
OUT
Pin capacitance
(all inputs/outputs)
—10pFVCC = 5.0V (Note)
T
A = 25°C, f = 1 MHz
D9 I
CC Read Operating current — 1 mA VCC = 5.5V, SCL = 400 kHz
I
CC Write — 3 mA VCC = 5.5V
D10 I
CCS Standby current — 5 μAVCC = 5.5VSCL = SDA = VCC
WP = VSS
Note: This parameter is periodically sampled and not 100% tested.