User`s guide

MPLAB IDE Windows
© 2006 Microchip Technology Inc. DS51519B-page 143
Export Table
Open the Export As dialog (see Section 13.10 “File Management Dialog”).
Fill Memory
Fill memory from Start Address to End Address with the value in Data. See
Section 13.11 “Fill Memory/Registers Dialog”.
Output to File
Write the displayed window contents to a text file. Uses a Save As dialog (see
Section 13.10 “File Management Dialog”), with the addition of an “Output Range”.
Select the type of range, either “Lines” or “Address”, and then enter the “Start” and
“End” values to output.
Print
Print the contents of the window.
Refresh
Refresh the data in this window.
Properties
Set up window properties. See Section 13.21.2 “General Tab”.
12.10.3 EEPROM Window FAQ
How do I:
Fill EEPROM memory with a value?
Right click in the window and select “Fill Registers” to open a dialog where you may
enter fill data.
If you are using a hardware debug tool, additional steps may be required to write
EEPROM on the part. See documentation for your tool.