User`s guide

MiWi™ P2P Wireless Networking Protocol Tools

5.2.5 Specifying PIC MCU Information

Select the PIC tab (refer to Figure 5-5).

FIGURE 5-5: ZENA™ STACK CONFIGURATION – MiWi™ P2P PROTOCOL

WINDOW, PIC

TAB

This tab is used to configure basic PIC MCU options.

TABLE 5-5: MiWi™ P2P PROTOCOL PIC

MCU CONFIGURATION SELECTION

Configuration Option Description

Target Device Family Select the device family of the application’s target processor.

Clock Frequency (Hz) Specify the input clock frequency to the PIC

MCU in Hertz. It is important that this

value is accurate since all internal MiWi™ P2P protocol timing will be based off this

value.

Output Stack Messages to

UART1

This option is targeted for use with either the PICDEM™ Z or Explorer 16 demo

board. If you want Stack operation messages to be sent to the UART so they can be

displayed on a terminal, select this option and select the desired baud rate.