User`s guide

MiWi™ P2P Wireless Networking Protocol Tools

5.2.2 Specifying Transceiver Information

Select the Transceiver tab (refer to Figure 5-2).

FIGURE 5-2: ZENA™ STACK CONFIGURATION – MiWi™ P2P PROTOCOL

WINDOW, TRANSCEIVER TAB

Using this window, you can configure the following items detailed in Table 5-2.

TABLE 5-2: MiWi™ P2P PROTOCOL TRANSCEIVER CONFIGURATION SELECTION

Configuration Option Description

Transceiver Select one of the transceivers supported by the Stack.

Frequency Band This combo box shows the various available frequency bands of the selected

transceiver. If the transceiver supports only one frequency band, that frequency will be

displayed and the combo box will be disabled.

Pin Assignments The Stack requires certain I/O pins to interface to the transceiver. If you are using the

PICDEM™ Z or Explorer 16 demo board, select the option to automatically configure the

Stack for that board. If you are using custom hardware, select “Custom Hardware”. You

are responsible for specifying the correct I/O pins for your custom hardware.