User`s guide

MiWi™ Wireless Networking Protocol Tools

4.2.5 Specifying PIC MCU Information

Select the PIC tab.

FIGURE 4-5: ZENA™ STACK CONFIGURATION – MiWi™ PROTOCOL

WINDOW, PIC

TAB

This tab is used to configure basic PIC MCU options.

TABLE 4-5: MiWi™ PROTOCOL PIC

MCU CONFIGURATION SELECTION

4.2.6 Generating the Configuration Files

When all of the options on all of the tabs are set appropriately, generate the Stack

configuration file by clicking Generate Files. The ZENA Wireless Network Analyzer will

first perform a validity check to ensure that all required fields have appropriate values

and all protocol-specific ranges are met.

If the validity check passes, the ZENA analyzer will prompt for an output directory for

the configuration file, MiWiDefs.h. This file has a time and date stamp included in the

file.

Configuration Option Description

Target Device Family Select the device family of the application’s target processor.

Clock Frequency (Hz) Specify the input clock frequency to the PIC

MCU in Hertz. It is important that this

value be accurate as all internal MiWi protocol timing will be based off of this value.

Output Stack Messages to

UART1

This option is targeted for use with either the PICDEM™ Z or Explorer 16 demo

board. If you want Stack operation messages to be sent to the UART so they can be

displayed on a terminal, select this option and select the desired baud rate.