User`s guide

ZENA™ Wireless Network Analyzer User’s Guide

3.2.4 Specifying Security Information

Select the Security tab.

FIGURE 3-5: ZENA™ STACK CONFIGURATION WINDOW, SECURITY TAB

This tab is used to configure the security features of the ZigBee protocol Stack. If your

application will utilize security, select the “Security Capable” option. Security imposes

the following constraints:

• The Stack requires one additional bank of RAM

• Neighbor table size is limited to 32 (see Table 3-10)

• The APS Address Map must be used (see Max APS Addresses in Table 3-7)

Using this window, you can configure the following items:

TABLE 3-4: ZigBee™ PROTOCOL DEVICE CONFIGURATION SELECTION

Configuration Option Description

Security Capable Select this option if your application will utilize security and send and receive

encrypted messages.

Security Mode Only “Residential” mode is currently supported by the Stack.

Trust Center Select this option if this device is the trust center.

Trust Center Address If the address of the trust center is known, enter it here.

Network Key Present If the network key is known, enter it here with the “Sequence Number”.

Key present in all devices on

the network

Select this option if the device is a ZigBee Coordinator or a ZigBee Router and it

contains the network key and all devices on the network contain the network key.