User`s guide

ZENA™ Wireless Network Analyzer User’s Guide

TABLE 3-3: ZigBee™ PROTOCOL PROFILE/ENDPOINTS CONFIGURATION SELECTION

Configuration Option Description

Profile Header File Click Browse to browse to and select the header file for the application’s profile. This

file has profile information in a specific format which the ZENA™ analyzer uses to

configure many items, including:

- Profile name

- The list of devices supported by the profile

- Allowable input and output clusters

- Range checking for various parameters on other tabs

Device

(1)

Select the profile device that describes the application.

Endpoints

(2)

To define an endpoint:

1. Enter the endpoint’s numerical value (1-240) in the “Endpoint” edit box.

2. In the “Endpoint Name” edit box, enter a valid C language label for that end-

point.

3. Select all of the input and output clusters that are supported by that endpoint

under “Input Clusters” and “Output Clusters”.

4. Click Save Endpoint to save the endpoint. The endpoint number will be added

to the “Endpoints” list box.

To define another endpoint:

1. Click New in the “Endpoints” list box. All of the endpoint information will be

cleared.

2. Enter the new endpoint’s information and click Save Endpoint.

To view a previously defined endpoint:

Click on the endpoint number in the “Endpoints” list box.

To remove a specified endpoint:

Click the desired endpoint number in the “Endpoints” list box and click Remove

Endpoint.

Note 1: The ZENA analyzer does not confirm that all mandatory clusters are supported for the selected device.

2: Be sure to click Save Endpoint when you are finished defining an endpoint. If the endpoint information

has been entered but not saved, the endpoint will not be included in the generated output files.