Datasheet

High-Speed Inter-Chip (HSIC) USB 2.0 Hub and Flash Media Controller
Datasheet
SMSC USB4640/USB4640i 51 Revision 1.3 (03-13-13)
DATASHEET
Chapter 6 DC Parameters
6.1 Maximum Guaranteed Ratings
Notes:
 Stresses above the specified parameters could cause permanent damage to the device. This is a
stress rating only. Therefore, functional operation of the device at any condition above those
indicated in the operation sections of this specification are not implied.
 When powering this device from laboratory or system power supplies, it is important that the
absolute maximum ratings not be exceeded or device failure can result. Some power supplies
exhibit voltage spikes on their outputs when the AC power is switched on or off. In addition, voltage
transients on the AC power line may appear on the DC output. When this possibility exists, it is
suggested that a clamp circuit be used.
PARAMETER SYMBOL MIN MAX UNITS COMMENTS
Storage
Temperature
T
STOR
-55 150 °C
Lead
Temperature
°C Refer to
JEDEC Specification
J-STD-020D [5].
1.2 V supply
voltage
VDD12 -0.5 1.5 V
3.3 V supply
voltage
VDD33 -0.5 4.0 V
Voltage on
USB+ and
USB- pins
-0.5 (3.3 V supply voltage + 2)
≤ 6V
Voltage on
GPIO10
-0.5 VDD33 + 0.3 V When internal power FET
operation of these pins are
enabled, these pins may be
simultaneously shorted to
ground or any voltage up to
3.63 V indefinitely, without
damage to the device as long
as VDD33 is less than 3.63 V
and T
A
is less than 70
o
C.
Voltage on
any signal pin
-0.5 VDD33 + 0.3 V
Voltage on
XTAL1
-0.5 3.6 V
Voltage on
XTAL2
-0.5 2.0 V