Datasheet

Highly Integrated Full Featured Hi-Speed USB 2.0 ULPI Transceiver
Datasheet
SMSC USB3320 65 Revision 1.0 (07-14-09)
DATASHEET
7.1.1.8 USB Interrupt Enable Rising
Address = 0D-0Fh (read), 0Dh (write), 0Eh (set), 0Fh (clear)
7.1.1.9 USB Interrupt Enable Falling
Address = 10-12h (read), 10h (write), 11h (set), 12h (clear)
DrvVbusExternal 6 rd/w/s/c 0b Enables external 5 volt supply to drive 5 volts on
VBUS. This signal is or’ed with DrvVbus.
0b: Do not drive Vbus, CPEN driven low.
1b: Drive Vbus, CPEN driven high.
UseExternalVbus
Indicator
7 rd/w/s/c 0b Tells the transceiver to use an external VBUS over-
current or voltage indicator. This function is detailed
in Section 5.6.2.
0b: Use the internal VbusValid comparator
1b: Use the EXTVBUS input as for VbusValid signal.
Note: The EXTVBUS signal is always high on the
USB3320.
FIELD NAME BIT ACCESS DEFAULT DESCRIPTION
HostDisconnect Rise 0 rd/w/s/c 1b Generate an interrupt event notification when
Hostdisconnect changes from low to high. Applicable
only in host mode.
VbusValid Rise 1 rd/w/s/c 1b Generate an interrupt event notification when
Vbusvalid changes from low to high.
SessValid Rise 2 rd/w/s/c 1b Generate an interrupt event notification when
SessValid changes from low to high.
SessEnd Rise 3 rd/w/s/c 1b Generate an interrupt event notification when
SessEnd changes from low to high.
IdGnd Rise 4 rd/w/s/c 1b Generate an interrupt event notification when IdGnd
changes from low to high.
Reserved 7:5 rd 000b Read only, 0.
FIELD NAME BIT ACCESS DEFAULT DESCRIPTION
HostDisconnect Fall 0 rd/w/s/c 1b Generate an interrupt event notification when
Hostdisconnect changes from high to low. Applicable
only in host mode.
VbusValid Fall 1 rd/w/s/c 1b Generate an interrupt event notification when
Vbusvalid changes from high to low.
SessValid Fall 2 rd/w/s/c 1b Generate an interrupt event notification when
SessValid changes from high to low.
SessEnd Fall 3 rd/w/s/c 1b Generate an interrupt event notification when
SessEnd changes from high to low.
IdGnd Fall 4 rd/w/s/c 1b Generate an interrupt event notification when IdGnd
changes from high to low.
FIELD NAME BIT ACCESS DEFAULT DESCRIPTION