Datasheet

20-Pin TSSOP and SSOP Evaluation Board User’s Guide

2.4.7 Evaluating the PIC24F16KA101 Device

(nanoWatt XLP PIC Microcontroller)

The PIC24F16KA101 is a nanoWatt XLP PIC Microcontroller that is offered in a 20-lead

SSOP package. This device can be installed on the bottom side of the PCB. Figure 2-8

shows the PIC24F16KA101’s pin out, while Figure 2-9 shows an example connection

for the ICSP interface and the connection of the crystal circuit to the secondary

oscillator.

Other nanoWatt XLP PIC Microcontrollers that are supported by this evaluation board

are shown in Table 2-5.

FIGURE 2-8: PIC24F16KA101 Pin Out.

FIGURE 2-9: PIC ICSP Header Example Connections (for PIC24F16KA101).

PIC24F16KA101

MCLR/VPP/RA5

OSCO/CLKO/AN5/C1INA/C2INC/CN29/RA3

PGC2/AN0/VREF+/CN2/RA0

PGD2/AN1/VREF-/CN3/RA1

PGD1/AN2/C1IND/C2INB/U2TX/CN4/RB0

PGC3/SOSCO/T1CK/U2CTS/CN0/RA4

PGD3/SOSCI/U2RTS/CN1/RB4

OSCI/CLKI/AN4/C1INB/C2IND/CN30/RA2

U1RX/U1BCLK/CN6/RB2

PGC1/AN3/C1INC/C2INA/U2RX/U2BCLK/CN5/RB1

VDD

VSS

U1TX/INT0/CN23/RB7

U1CTS/SCL1/CN22/RB8

REFO/SS1/T2CK/T3CK/CN11/RB15

AN10/CVREF/RTCC/SDI1/OCFA/C1OUT/INT1/CN12/RB14

AN11/SDO1/CTPLS/CN13/RB13

AN12/HLVDIN/SCK1/CTED2/CN14/RB12

U1RTS/SDA1/CN21/RB9

OC1/IC1/C2OUT/INT2/CTED1/CN8/RA6

“Jumpers” for ICSP operation.

Note: LVP signal is not connected and

Capacitor value dependent on

crystal and oscillator mode selected.

VDD, VSS are connected to

appropriate signal plane.