User manual

ICP Family User’s Manual
Rev: 4.7.3 Jan-2011 Page 10 of 18
11 Shortcuts
Save Ctrl-S
Open... Ctrl-O
Program F5
Verify F6
Blank Check F7
Read F8
Programming Only F9
Menu F10
Close Window Ctrl-F4
Exit Alt-F4
12 Preparing Environment and Transferring Environment to
Programmer
 Run “Environment/Environment Wizard” and follow the Wizard
 Select programmer and press “Next”
 ICP2-GANG only: select GANG channels and press “Next”
ICP2-Portable only: select environment number and press “Next”
 Select Device
From the "Device" list select a device to be programmed and press “Next”
 Set Voltages and press “Next”
 Load (open) a HEX file.
NOTE: The programmer software is able to read ID information, data memory (EEPROM) contents and
configuration bits from the HEX file
 Save Environment
- Press on “…” button
- Type in environment name, 16 characters max
- Press “Save”
- Press “Next”
 Transfer Environment to Programmer
- Press on “Transfer Environment” button, select your environment and press “Open”
- Wait until environment is transferred to all channels
- Press “Next”
 Switch to Standalone Mode
- Press on “Standalone Mode” button
- Press “Finish"
 Your system is ready for standalone programming