User manual

ICP Family User’s Manual
Rev: 4.7.3 Jan-2011 Page 9 of 18
Save Configuration Save all current settings
Exit Exit the software
10.2 Edit Menu (Alt-E)
Edit/Fill Program Memory Fill an area of the Program Memory with a specified value
Edit/Fill Data Memory Fill an area of the Data Memory (EEPROM) with a specified value
Read-only Editors Enable/disable edit of Program and Data Memory buffers
10.3 Environment (Alt-P)
Save Environment As… Save current setup and buffers in environment format (*.pj2)
Transfer Environment to Programmer… Transfer Environment (*.pj2) to programmer
Environment Wizard…
10.4 Serialization Menu (Alt-S)
Disable Disable serialization
Load File Load serialization file
Create File Create serialization file
10.5 Device Menu (Alt-D)
Select a type of device to be programmed
10.6 Programmer Menu (Alt-G)
Select Programmer Select programmer (ICP2/ICP2(HC) or ICP2-GANG)
GANG Configuration Select active GANG channels (64 max)
Assign Address to GANG Box Assign address to currently connected programmer (1-16). See
“ICP2-GANG Quick Start” for details
Quick Start Wizard
10.7 Run Menu (Alt-R)
Program PC-driven mode: program data in the buffer(s) into the device
Standalone mode: activate standalone programming
Verify Verify the data in the device against the data in the buffer(s)
Blank Check Check the data in the device for the blank state
Read Read the device and store the data in the buffers
Program Only Open a window for repeated programming
10.8 Communication Menu (Alt-C)
RS-232/USB/Bluetooth COM Select the desired COM port
Connect Connect to the programmer
10.9 Options Menu (Alt-O)
Voltage Set desired voltages
Clock/Data/MCLR(Advanced) Set desired Clock/Data/MCLR parameters
Preferences Select options for programming
Firmware Upgrade Execute firmware upgrade
Activation of Options Execute activation of optional components:
- DLL/Command Line Support (D)
- dsPIC®/PIC24 Support (P)
- Keeloq® Support (K)
- Secure Programming Support (S)
- PIC32 Support (X)
Note: Contact Softlog Systems for activation details
10.10 Help Menu (Alt-H)
Read me Display "Readme_w.txt" file
About Connect with the programmer and display software and
firmware versions