User manual

ICP Family User’s Manual
Rev: 4.7.3 Jan-2011 Page 6 of 18
3 PASS/FAIL LEDs and Outputs
###
Conditions
PASS LED
FAIL LED
PASS Output
FAIL Output
1.
Power-up
2 sec ON
2 sec ON
2.
Operation in-progress
(busy)
ON
ON
3.
Programming done: PASS
ON
OFF
ON
OFF
4.
Programming done: FAIL
(verification error)
OFF
ON
OFF
ON
5.
UUT problem during
operation:
- Vdd overload
- Vpp overload
- I2C communication error
OFF
Blink
OFF
ON
6.
Non-UUT problem during
standalone operation:
- database error
- device not supported
- no Keeloq® support
- no dsPIC® support
- etc.
OFF
Blink
OFF
OFF
7.
No firmware presents
(bootloader only)
Slow blink
OFF
OFF (not supported)
8.
Firmware upgrade
in-progress
Fast blink
OFF
OFF (not supported)
4 Other LEDs (ICP2-Portable)
See “ICP2-Portable Quick Start.pdf”
5 Standalone Operation without PC
 Prepare an environment and transfer to programmer – see paragraph 12 for details
NOTE: once the environment is saved in non-volatile memory it’s automatically ready for programming
 Short pin GO (:13) of the target connector to GND (:12) for at least 100ms to start programming
 Observe PASS/FAIL LEDs or/and pins PASS (:14) and FAIL(:15) – see paragraph 3 for details
6 Host Computer Requirements
 Pentium-4 or greater IBM PC compatible
 Resolution 1024x768 or higher
 64MBytes of RAM
 Windows-XP/Vista/7. Contact Softlog Systems for operation with Win-95/98/NT/2000
 At least 50MBytes of hard disk space
 CD-ROM drive
 Free RS-232 or USB port
7 Installation
7.1 Preliminary Installation
7.1.1 Software Installation
To install the software supplied, follow the steps below: