Datasheet
Table Of Contents
- Features
- Product Description
- Block Diagram
- Pin Description
- Product Identification
- Memory Organization
- Device Operation
- Electrical Specifications
- Table 7: Operating Range
- Table 8: AC Conditions of Test
- Table 9: DC Operating Characteristics VDD = 2.7-3.6V
- Table 10: Recommended System Power-up Timings
- Table 11: Capacitance (TA = 25°C, f=1 Mhz, other pins open)
- Table 12: Reliability Characteristics
- Table 13: AC Operating Characteristics VDD = 2.7-3.6V
- Product Ordering Information
- Packaging Diagrams
©2011 Silicon Storage Technology, Inc. S725081A 10/11
18
1 Mbit SPI Serial Flash
SST25VF010A
Data Sheet
A
Microchip Technology Company
Read-ID
The Read-ID instruction identifies the device as SST25VF010A and manufacturer as SST. The device
information can be read from executing an 8-bit command, 90H or ABH, followed by address bits [A
23
-
A
0
]. Following the Read-ID instruction, the manufacturer’s ID is located in address 00000H and the
device ID is located in address 00001H. Once the device is in Read-ID mode, the manufacturer’s and
device ID output data toggles between address 00000H and 00001H until terminated by a low to high
transition on CE#.
Figure 15:Read-ID Sequence
1265 F15.0
CE#
SO
SI
SCK
00
012345678
00 ADD
1
90 or AB
HIGH IMPEDANCE
15 16
23
24
31
32
39
40
47 48 55 56 63
BF
Device ID
BF
Device ID
Note: The manufacturer s and device ID output stream is continuous until terminated by a low to high transition on CE#.
1. 00H will output the manfacturer s ID first and 01H will output device ID first before toggling between the two.
HIGH
IMPEDANCE
MODE 3
MODE 0
MSB MSB
MSB