Datasheet

©2011 Silicon Storage Technology, Inc. S725081A 10/11
15
1 Mbit SPI Serial Flash
SST25VF010A
Data Sheet
A
Microchip Technology Company
Chip-Erase
The Chip-Erase instruction clears all bits in the device to FFH. A Chip-Erase instruction will be ignored
if any of the memory area is protected. Prior to any Write operation, the Write-Enable (WREN) instruction
must be executed. CE# must remain active low for the duration of the Chip-Erase instruction sequence.
The Chip-Erase instruction is initiated by executing an 8-bit command, 60H or C7H. CE# must be driven
high before the instruction is executed. The user may poll the Busy bit in the software status register or wait
T
CE
for the completion of the internal self-timed Chip-Erase cycle. See Figure 10 for the Chip-Erase
sequence.
Figure 10:Chip-Erase Sequence
Read-Status-Register (RDSR)
The Read-Status-Register (RDSR) instruction allows reading of the status register. The status register
may be read at any time even during a Write (Program/Erase) operation. When a Write operation is in
progress, the Busy bit may be checked before sending any new commands to assure that the new
commands are properly received by the device. CE# must be driven low before the RDSR instruction is
entered and remain low until the status data is read. Read-Status-Register is continuous with ongoing
clock cycles until it is terminated by a low to high transition of the CE#. See Figure 11 for the RDSR
instruction sequence.
Figure 11:Read-Status-Register (RDSR) Sequence
CE#
SO
SI
SCK
01234567
60 or C7
HIGH IMPEDANCE
MODE 0
MODE 3
1265 F10.0
MSB
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
1265 F11.0
MODE 3
SCK
SI
SO
CE#
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
05
MODE 0
HIGH IMPEDANCE
Status
Register Out
MSB
MSB