User manual

SC70-6 AND SOT-23-6/8 TO DIP-8
EVALUATION BOARD USER’S GUIDE
© 2009 Microchip Technology Inc. DS51874A-page 31
Appendix B. Bill of Materials (BOM)
TABLE B-1: BILL OF MATERIALS
Qty Reference Description Manufacturer Part Number
1 PCB RoHS Compliant Bare PCB, SC70-6 and-
SOT-23-6/8 to DIP-8 Evaluation Board
Microchip
Technology Inc.
104-00273
0 C1, C2 Device Power Supply inltering Capacitor
Surface-mount (805 package)
(Optional - Application-dependent)
— User-specified
0 J1 PICkit Serial or BFMP Header
(6-pin, 100 mil spacing)
——
0 P1, P2, P3, P4,
P5, P6, P7, P8,
V
DD
, V
SS
Through-hole connector(s) for P1, P2, P3, P4,
P5, P6, P7, P8, V
DD
, V
SS
Keystone
Electronics
®
5012
0 P1, P2, P3, P4,
P5, P6, P7, P8,
V
DD
, V
SS
Surface-mount connector(s) for P1, P2, P3, P4,
P5, P6, P7, P8, V
DD
, V
SS
Keystone
Electronics
®
5016
0 R1U, R2U, R3U,
R4U, R5U, R6U,
R7U, R8U
Pin Pull-up resistor
Surface-mount (805 package)
(Optional - Application-dependent)
— User-specified
0 R3A, R3B, R3C,
R3D, R3E, R3F,
R3G, R3H
Pin Pull-down resistor
(1)
Surface-mount (805 package)
(Optional - Application-dependent)
— User-specified
0 U1 SC70-6 Device (supports SC70-5 and SC70-3
devices)
— User-specified
0 U2 SOT23-8 Device — User-specified
0 U3 DIP-8 Device — User-specified
0 U4 SOT23-6 Device (Supports SOT23-5 and
SOT23-3 devices)
— User-specified
Note 1: These footprints could be used for pin signal filtering by using a capacitor.
2: The components listed in this Bill of Materials are representative of the PCB assembly. The released BOM
used in manufacturing uses all RoHS-compliant components