User's Manual

ManualsBrandsMicrochip Technology ManualsElectronicsClass 1 Bluetooth Module

Table Of Contents

www.rovingnetworks.com Version 3.43 5/21/13 page 11

RN41-DS

3.0 REGULATORY APPROVAL

This section outlines the regulatory information for the

RN-41/RN-41N module for the following countries:

• United States

• Canada

• Europe

•Australia

• New Zealand

3.1 United States

The RN-41/RN-41N module has received Federal

Communications Commission (FCC) CFR47 Telecom-

munications, Part 15 Subpart C “Intentional Radiators”

modular approval in accordance with Part 15.212 Mod-

ular Transmitter approval. Modular approval allows the

end user to integrate the RN-41/RN-41N module into a

finished product without obtaining subsequent and sep-

arate FCC approvals for intentional radiation, provided

no changes or modifications are made to the module

circuitry. Changes or modifications could void the

user’s authority to operate the equipment. The end

user must comply with all of the instructions provided

by the Grantee, which indicate installation and/or oper-

ating conditions necessary for compliance.

The finished product is required to comply with all appli-

cable FCC equipment authorizations regulations,

requirements and equipment functions not associated

with the transmitter module portion. For example, com-

pliance must be demonstrated to regulations for other

transmitter components within the host product; to

requirements for unintentional radiators (Part 15 Sub-

part B “Unintentional Radiators”), such as digital

devices, computer peripherals, radio receivers, etc.;

and to additional authorization requirements for the

non-transmitter functions on the transmitter module

(i.e., Verification, or Declaration of Conformity) (e.g.,

transmitter modules may also contain digital logic func-

tions) as appropriate.

3.1.1 LABELING AND USER

INFORMATION REQUIREMENTS

The RN-41/RN-41N module has been labeled with its

own FCC ID number, and if the FCC ID is not visible

when the module is installed inside another device,

then the outside of the finished product into which the

module is installed must also display a label referring to

the enclosed module. This exterior label can use word-

ing as follows:

RN-41:

Contains Transmitter Module FCC ID: T9JRN41-3

Contains FCC ID: T9JRN41-3

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation

RN-41N:

Contains Transmitter Module FCC ID: OA3-RN41N

Contains FCC ID: OA3-RN41N