User's Manual

Federal Communications Commission (FCC) Requirements
This equipment has been tested and found to comply with the limits for a Class B digi
tal device, pursuant to part 15 of the FCC rules. These limits are designed to provide r
easonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not insta
lled and used in accordance with the instructions, may cause harmful interference to r
adio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the followi
ng measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution :
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to
operate this equipment. (Example - use only shielded interface cables when
connecting to computer or peripheral devices).
This Transmitter must not be colocated or operating in conjunction with any other ant
enna or transmitter. Any changes or modifications (including the antennas) made to th
is device that are not expressly approved by the manufacturer may void the user’s aut
hority to operate the equipment.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may b
e installed such that 20 cm may be maintained between the antenna and users. The fin
al end product must be labeled in visible area with the following:
“Contains FCC ID: T9J-RN24 ”
End Product Manual Information
The user manual for end users must include the following information in a prominent
location “IMPORTANT NOTE: To comply with FCC RF exposure compliance requir
ements, the antenna used for this transmitter must be installed to provide a separation