User's Manual

WiFly GSX
www.rovingnetworks.com WiFlyRN171-um 2/23/2011
809 University Avenue • Los Gatos, CA 95032 •Tel [phone] •[e-mail]
~22~
9 9 Mbit/sec
10 12 Mbit/sec
11 18 Mbit/sec
12 24 Mbit/sec (default)
13 36 Mbit/sec
14 48 Mbit/sec
15 54 Mbit/sec
setwlanssid<string> sets the wlanssid to associate with. 1-32 chars.
NOTE: If the passphrase or ssid contain the SPACE ( ‘ ‘)
characterS, these can be entered using substitution via the “$” character.
For example, if the ssid of the AP is “yellow brick road”
You would enter “yellow$brick$road”
Using the ‘get w” command will properly display the value:
SSID=yellow brick road.
setwlan window <value> sets the IP maximum buffer window size. Default is 1460 bytes.
5.12. Sensor Parameters
set q sensor <mask> Bitmask value that determines which sensor pins to sample when sending
data using the UDP broadcast packet, or the HTTP auto sample function.
NOTE: The sensor pins variable has been changed from
“set option sensor <mask>” to set q sensor <mask> in ver 2.21.1
set q power <value> This is a new register added in ver 2.21.1 to automatically turn on the
sensor power. This is a 8 bit register with two 4 bit nibbles. If the top nibble is
set, then power is applied upon power up and removed upon power down or
sleep.
If the bottom nibble is set, then power is applied when a sampling event
occurs, for example:
• The UDP Broadcast
• The auto web posting of sensor data
The power is removed immediately after the sampling is complete.
The values used for setting the power are described in the table below:
Value Sensor pin voltage