User's Manual

Roving Networks Wifly RN-111B User Guide Version 1.16
www.rovingnetworks.com
[e-mail]
Phone [phone]
- 16 -
3.2. GET COMMANDS
These commands begin with “get”. They represent the stored values as configured.
get com display comm. settings.
get ip display IP address and port number settings.
get mac display the device MAC address.
get port return current value of the PIO pins in hex format.
get sys display system settings, sleep, wake timers, etc.
get time display the time server UDP address and port number.
get wlan display the ssid, chan, and other wlan settings.
get uart display the UART settings.
In addition to the above, there are a few other useful commands available.
ver return the software release version
3.3. STATUS COMMANDS
These commands begin with “show”, and they return the current values of
variables in the system. In some cases, for example IP addresses, the current values
are received from the network, and may not match the stored values.
show net Displays current network status, association, authentication, etc.
show rssi Displays current last received signal strength.
show stats Displays current statistics, packet rx/tx counters, etc.
show time Displays number of seconds since last powerup or reboot