User's Manual

Roving Networks Wifly RN-111B User Guide Version 1.16
www.rovingnetworks.com
[e-mail]
Phone [phone]
- 14 -
set ip remote <value> sets the remote host port number.
set ip ftp <addr> sets the ftp server address.
set ip uport <num> sets the ftp server port number.
SYSTEM PARAMETERS
set sys autoconn <secs> TCP mode: sets the auto-connect TCP timer. 0 disables.
set sys autosleep <num *10ms> UDP mode: sets the auto-sleep timer. 0 disables.
set sys iofunc <value> sets the IO port alternate functions. Bit-mapped value.
set sys mask <mask> sets the IO port direction mask. Bit-mapped value.
set sys printlvl <value> sets numerous print functions. Bit-mapped value.
set sys output <value> <mask> sets output PIO pins to HIGH or LOW.
Bit-mapped value. Optional mask only sets a subset of pins.
set sys sleep <secs> sets the sleep timer. 0 disables.
set sys trigger <value> sets the sensor input to wake on (1-4). 0 disables.
set sys wake <secs> sets the auto wake timer. 0 disables.
TIME SERVER PARAMETERS
set time address <addr> sets the time server address. This is also the server
address for UDP packet mode.
set time port <num> sets the time server port number.
set time enable <0,1,2> Enable or disable time server. 1= get time on powerup.
2=get time continuously every 60 seconds.
UART PARAMETERS
set uart parity <n,e,o> sets the UART parity.
Example : “set u p e” sets even parity
set uart baud <rate> {1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200,
230400, 460800, 921600 }.
Example : “set u b 9600” sets the baudrate to 9600 baud.
set uart raw <rate> sets a RAW uart value. Used to set non-standard rates.
Example : “set u r 760” sets the baudrate to 7200 baud.