Datasheet

PICkit™ SERIAL I

C™ DEMO

BOARD USER’S GUIDE

Chapter 2. Installation and Operation

2.1 I

C DEMO BOARD OPERATION

The PICkit™ Serial I

C™ Demo Board was designed to easily connect to the PICkit

Serial Analzyer (DV164122). Refer to the PICkit Serial Analyzer User’s Guide

(DS51647) chapter on I

C Master Communications mode for configuration and

operation information of the PICkit Serial Analyzer.

The PICkit Serial Analyzer provides the I

C master mode serial communications and

power. The PICkit™ Serial I

C™ Demo Board devices all operate in the I

C slave

mode. Figure 2-1 shows the PICkit™ Serial I

C™ Demo Board block diagram.

Pull-up resistors R2 and R3 are not populated. The PICkit Serial Analyzer can be

configured to enable internal pull-up resistors. When using the PICkit Serial Analyzer,

enable internal pull-up resistors. Or resistors R2 and R3 can be populated by the user

for use with other development boards or the PICkit Serial Analyzer internal pull-up

resistors disabled.

FIGURE 2-1: PICkit™ Serial I

C™ Demo Board Block Diagram.

Connector P1 connects to the PICkit Serial Analyzer or virtually any demo or

development board. Connector P1 pin assignments are listed in Table 2-1.

TABLE 2-1: I

C DEMO BOARD CONNECTOR P1 PIN ASSIGNMENTS

24LC02B MCP9800 MCP3221 TC1321 MCP23008

SDA

SCL

Pin Label Type Description

1 — — No Connection

2 +V Power Power

3 GND Ground Ground

4 SDA Input/Output Serial Data

5 SCL Input Serial Clock

6 — — No Connection