Datasheet

 2009-2013 Microchip Technology Inc. DS60001156H-page 435
PIC32MX5XX/6XX/7XX
Revision G (May 2011)
The revision includes the following global update:
• All references to V
DDCORE/VCAP have been
changed to: VCORE/VCAP
• Added references to the new V-Temp temperature
range: -40ºC to +105ºC
This revision also includes minor typographical and
formatting changes throughout the data sheet text.
Major updates are referenced by their respective
section in Table B-5.
TABLE B-5: MAJOR SECTION UPDATES
Section Name Update Description
High-Performance, USB, CAN and
Ethernet 32-bit Flash Microcontrollers
Removed the shading for all D- and D+ pins in all pin diagrams.
1.0 “Device Overview” Updated the V
BUS description in Table 1-1.
1.0 “Guidelines for Getting Started with
32-bit Microcontrollers”
Added “Alternatively, inputs can be reserved by connecting the pin
to Vss through a 1k to 10k resistor and configuring the pin as an
input.”.
4.0 “Memory Organization” Added Note 3 to the Interrupt Register Map tables (see Table 4-2 through
Table 4-7.
22.0 “10-bit Analog-to-Digital Converter
(ADC)”
Updated the ADC Conversion Clock Period Block Diagram (see
Figure 22-2).
1.0 “Comparator Voltage Reference
(CV
REF)”
Updated the Comparator Voltage Reference Block Diagram (see
Figure 1-1).
1.0 “Special Features” Removed the second paragraph from 1.3.1 “On-Chip Regulator and
POR”.
1.0 “Electrical Characteristics” Added the new V-Temp temperature range (-40ºC to +105ºC) to the
heading of all specification tables.
Updated the Ambient temperature under bias, updated the Voltage on
any 5V tolerant pin with respect to V
SS when VDD < 2.3V, and added
Voltage on VBUS with respect to Vss in Absolute Maximum Ratings.
Added the characteristic, DC5a to Operating MIPS vs. Voltage (see
Table 1-1).
Updated or added the following parameters to the Operating Current
(I
DD) DC Characteristics: DC20, DC20b, DC23, and DC23b (see Table 1-
5).
Added the following parameters to the Idle Current (I
IDLE) DC
Characteristics: DC30b, DC33b, DC34c, DC35c, and DC36c (see
Table 1-6).
Added the following parameters to the Power-down Current (I
PD) DC
Characteristics: DC40g, DC40h, DC40i, and DC41g, (see Table 1-7).
Added parameter IM51 and Note 3 to the I2Cx Bus Data Timing
Requirements (Master Mode) (see Table 1-32).
Updated the 10-bit ADC Conversion Rate Parameters (see Table 1-37).
Updated parameter AD57 (T
SAMP) in the Analog-to-Digital Conversion
Timing Requirements (see Table 1-38).
1.0 “Packaging Information” Updated the 64-Lead Plastic Quad Flat, No Lead Package (MR) –
9x9x0.9 mm Body [QFN] packing diagram.
Product Identification System Added the new V-Temp (V) temperature information.