Datasheet
PIC32MX5XX/6XX/7XX
DS60001156H-page 364 2009-2013 Microchip Technology Inc.
TABLE 31-6: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 2.3V to 3.6V
(unless otherwise stated)
Operating temperature -40°C T
A +85°C for Industrial
-40°C TA +105°C for V-Temp
Parameter
No.
Typical
(2)
Max. Units Conditions
Idle Current (I
IDLE)
(1)
for PIC32MX575/675/695/775/795 Family Devices
DC30 4.5 6.5
mA
-40ºC, +25ºC, +85ºC
—4 MHz
DC30b 5 7 +105°C
DC31 13 15 mA -40ºC, +25ºC, +85ºC — 25 MHz (Note 3)
DC32 28 30 mA -40ºC, +25ºC, +85ºC — 60 MHz (Note 3)
DC33 36 42 mA -40ºC, +25ºC, +85ºC
—80 MHz
DC33b 39 45 mA +105°C
DC34
—
40
µA
-40°C
2.3V
LPRC (31 kHz)
(Note 3)
DC34a 75 +25°C
DC34b 800 +85°C
DC34c 1000 +105°C
DC35 35
—µA
-40°C
3.3V
DC35a 65 +25°C
DC35b 600 +85°C
DC35c 800 +105°C
DC36
—
43
µA
-40°C
3.6V
DC36a 106 +25°C
DC36b 800 +85°C
DC36c 1000 +105°C
Note 1: The test conditions for I
IDLE current measurements are as follows:
• Oscillator mode is EC (for 8 MHz and below) and EC+PLL (for above 8 MHz) with OSC1 driven by
external square wave from rail-to-rail, (OSC1 input clock input over/undershoot < 100 mV required)
• OSC2/CLKO is configured as an I/O input pin
• USB PLL oscillator is disabled if the USB module is implemented, PBCLK divisor = 1:8
• CPU is in Idle mode, program Flash memory Wait states = 111, Program Cache and Prefetch are dis-
abled and SRAM data memory Wait states = 1
• No peripheral modules are operating, (ON bit = 0)
• WDT, Clock Switching, Fail-Safe Clock Monitor, and Secondary Oscillator are disabled
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD
• RTCC and JTAG are disabled
2: Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
3: This parameter is characterized, but not tested in manufacturing.