Datasheet
PIC32MX Starter Kit User’s Guide
DS61144D-page 30 © 2009 Microchip Technology Inc.
3.3.5 Task 5, Confirm the Configuration Settings
Click Configure>Configuration Bits to confirm that the configuration settings are cor-
rect. Typical configuration settings for the starter kit are shown in Figure 3-6.
FIGURE 3-6: CONFIGURATION BIT SETTINGS
Note: The “Configuration Bits set in code” check box must be unchecked if the
config bits are set via this window and not in the code.
The configuration settings can also be embedded in the source file.
See the MPLAB C Compiler for PIC32 User’s Guide (DS51686) for
information.
CAUTION
Setting the PIC32 Starter Kit configuration bits to cause the PIC32MX to oper-
ate faster than the maximum 80MHz system clock speed may cause the
PIC32MX to stop communicating with the PIC18F4550 Starter Kit debugger.
Should this occur, run the
sk_erase.exe utility to re-flash the PIC32MX with a
default configuration. This utility is located on the PIC32 Starter Kit CD or in
the PIC32MX Starter Kit directory:
[install directory]\PIC32 Starter Kits\tools