Datasheet

PIC32MX1XX/2XX
DS61168E-page 248 Preliminary  2011-2012 Microchip Technology Inc.
TABLE 29-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.3V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +105°C for V-temp
Param.
No.
Typical
(2)
Max. Units Conditions
Power-Down Current (IPD) (Note 1)
DC40k 10 16 A-40°C
Base Power-Down Current
DC40l 44 70 A+25°C
DC40n 168 259 A+85°C
DC40m 335 536 µA +105ºC
Module Differential Current
DC41e 5 20 A 3.6V Watchdog Timer Current: I
WDT (Note 3)
DC42e 23 50 A 3.6V RTCC + Timer1 w/32 kHz Crystal: I
RTCC (Note 3)
DC43d 1000 1100 A 3.6V ADC: IADC (Notes 3,4)
Note 1: The test conditions for I
PD current measurements are as follows:
• Oscillator mode is EC (for 8 MHz and below) and EC+PLL (for above 8 MHz) with OSC1 driven by
external square wave from rail-to-rail, (OSC1 input clock input over/undershoot < 100 mV required)
• OSC2/CLKO is configured as an I/O input pin
• USB PLL oscillator is disabled if the USB module is implemented, PBCLK divisor = 1:8
• CPU is in Sleep mode, and SRAM data memory Wait states = 1
• No peripheral modules are operating, (ON bit = 0), but the associated PMD bit is set
• WDT, Clock Switching, Fail-Safe Clock Monitor, and Secondary Oscillator are disabled
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD
• RTCC and JTAG are disabled
2: Data in the “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
3: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.
4: Test conditions for ADC module differential current are as follows: Internal ADC RC oscillator enabled.