Datasheet

 2011-2012 Microchip Technology Inc. Preliminary DS61168E-page 163
PIC32MX1XX/2XX
16.0 SERIAL PERIPHERAL
INTERFACE (SPI)
The SPI module is a synchronous serial interface that
is useful for communicating with external peripherals
and other microcontroller devices. These peripheral
devices may be Serial EEPROMs, Shift registers, dis-
play drivers, Analog-to-Digital Converters (ADC), etc.
The PIC32 SPI module is compatible with Motorola
®
SPI and SIOP interfaces.
Some of the key features of the SPI module are:
• Master and Slave modes support
• Four different clock formats
• Enhanced Framed SPI protocol support
• User-configurable 8-bit, 16-bit and 32-bit data width
• Separate SPI FIFO buffers for receive and transmit
- FIFO buffers act as 4/8/16-level deep FIFOs
based on 32/16/8-bit data width
• Programmable interrupt event on every 8-bit,
16-bit and 32-bit data transfer
• Operation during CPU Sleep and Idle mode
• Audio Codec Support:
-I
2
S protocol
- Left-justified
- Right-justified
-PCM
FIGURE 16-1: SPI MODULE BLOCK DIAGRAM
Note 1: This data sheet summarizes the features
of the PIC32MX1XX/2XX family of
devices. It is not intended to be a
comprehensive reference source. To
complement the information in this data
sheet, refer to Section 23. “Serial
Peripheral Interface (SPI)” (DS61106) in
the “PIC32 Family Reference Manual”,
which is available from the Microchip web
site (www.microchip.com/PIC32).
2: Some registers and associated bits
described in this section may not be
available on all devices. Refer to
Section 4.0 “Memory Organization” in
this data sheet for device-specific register
and bit information.
Internal
Data Bus
SDIx
SDOx
SSx
/FSYNC
SCKx
SPIxSR
bit 0
Shift
Control
Edge
Select
MSTEN
Baud Rate
Slave Select
Sync Control
Clock
Control
Transmit
Receive
and Frame
Note: Access SPIxTXB and SPIxRXB FIFOs via SPIxBUF register.
FIFOs Share Address SPIxBUF
SPIxBUF
Generator
PBCLK
WriteRead
SPIxTXB FIFO
SPIxRXB FIFO
REFCLK
MCLKSEL