Information
© 2009-2011 Microchip Technology Inc. DS80467G-page 9
PIC24HJ32GP202/204 and PIC24HJ16GP304
25. Module: CPU
When a previous DISI instruction is active (i.e.,
the DISICNT register is non-zero), and the value of
the DISICNT register is updated manually, the
DISICNT register freezes and disables interrupts
permanently.
Work around
Avoid updating the DISICNT register manually.
Instead, use the DISI #n instruction with the
required value for 'n'.
Affected Silicon Revisions
26. Module: CPU
When using the Signed 32-by-16-bit Division
instruction, div.sd, the overflow bit does not
always get set when an overflow occurs.
Work around
Test for and handle overflow conditions outside of
the div.sd instruction.
Affected Silicon Revisions
27. Module: UART
When using UTXISEL = 01 (Interrupt when last
character is shifted out of the Transmit Shift
Register) and the final character is being shifted
out through the Transmit Shift Register, the
Transmit (TX) Interrupt may occur before the final
bit is shifted out.
Work around
If it is critical that the interrupt processing occur
only when all transmit operations are complete.
Hold off the interrupt routine processing by adding
a loop at the beginning of the routine that polls the
Transmit Shift Register Empty bit (TRMT) before
processing the rest of the interrupt.
Affected Silicon Revisions
28. Module: JTAG
JTAG Flash programming is not supported.
Work around
None.
Affected Silicon Revisions
A2 A3 A4 A5 A6
XXXX
X
A2 A3 A4 A5 A6
XXXXX
A2 A3 A4 A5 A6
XXXXX
A2 A3 A4 A5
A6
XXXXX