Datasheet

PIC24HJ32GP202/204 AND PIC24HJ16GP304
DS70289J-page 208 © 2007-2011 Microchip Technology Inc.
IICL Input Low Injection Current
DI60a
0—-5
(5,8)
mA
All pins except VDD, VSS,
AV
DD, AVSS, MCLR, VCAP,
SOSCI, SOSCO, and RB14
IICH Input High Injection Current
DI60b
0—+5
(6,7,8)
mA
All pins except V
DD, VSS,
AV
DD, AVSS, MCLR, VCAP,
SOSCI, SOSCO, RB14,
and digital 5V-tolerant
designated pins
IICT Total Input Injection Current
DI60c (sum of all I/O and control pins) -20
(9)
—+20
(9)
mA Absolute instantaneous
sum of all ± input injection
currents from all I/O pins
(| I
ICL + | IICH |) IICT
TABLE 22-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C TA +85°C for Industrial
-40°C TA +125°C for Extended
Param
No.
Symbol Characteristic Min Typ
(1)
Max Units Conditions
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See the Pin Diagrams section for a list of digital-only and analog pins.
5: V
IL source < (VSS – 0.3). Characterized but not tested.
6: Non-5V tolerant pins V
IH source > (VDD + 0.3), 5V tolerant pins VIH source > 5V or devices with USB, “D+”
and “D-“ VIH source > (VUSB + 0.3). Characterized but not tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins not excluded under I
ICL or IICH conditions are permitted pro-
vided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit. Characterized but not tested.