Datasheet

 2010 Microchip Technology Inc.
PIC24FJ64GB004 FAMILY
APPENDIX A: REVISION HISTORY
Revision A (April 2009)
Original data sheet for the PIC24FJ64GB004 family of
devices.
Revision B (July 2009)
Removed the unimplemented CNPD1 and CNPD2
registers from Table 4-4. Corrected the addresses of
the CNPU1 and CNPU2 registers in the same table.
Updated Table 6-2 (Reset Delay Times) with the
addition of T
RSRT to all table entries.
Updated Register 7-35 (INTTREG) with a more
descriptive version.
Updated Section 9.2.4 “Deep Sleep Mode” with
family-specific information and an extended discussion
of special cases for Deep Sleep mode entry.
Updated Section 29.1 “DC Characteristics” as
follows:
• Added Maximum values to Tables 29-4, 29-5,
29-6 and 29-7.
• Updated specifications in Tables 29-3 and 29-8.
• Added new Tables 29-11 (Comparator Specifica-
tions) and 29-12 (Comparator Voltage Reference
Specifications), renumbering all subsequent
tables.
• Removed redundant or obsolete specifications in
Tables 29-6, 29-7 and 29-12.
Updated Section 29.2 “AC Characteristics and
Timing Parameters” as follows:
• Updated specifications in Tables 29-17 and
29-19.
• Added new Table 29-21 (Reset, Power-up Timer
and Brown-out Reset Timing Requirements),
renumbering all subsequent tables.
Other minor typographic revisions throughout the
document.
Revision C (October 2009)
Corrected Section 10.3 “Input Change Notification”
regarding the number of ICN inputs and the availability
of pull-downs.
Updated Section 10.4.2 “Available Peripherals” by
removing the Timer 1 clock input from Table 10-2.
Updated Section 29.1 “DC Characteristics” as
follows:
• Added new specifications to Tables 29-4 and 29-5
for I
DD and IIDLE at 0.5 MIPS operation.
• Updated Table 29-4 with revised maximum IDD
specifications for 1 MIPS and 4 MIPS.
• Renumbered the parameters for the delta I
PD
current (32 kHz, SOSCEL = 11) from DC62n to
DC63n.
Revision D (August 2010)
Updated Section 10.4.5 “Considerations for
Peripheral Pin Selection” as follows:
• Replaced the code in Example 10-1.
• Added the new code in Example 10-3.
Updated Figure 18-1 in Section 18.0 “Universal
Serial Bus with On-The-Go Support (USB OTG)”
Updated Section 29.1 “DC Characteristics”as
follows:
• Added the “125°c data” in
Table 29-4,Table 29-5,Table 29-6 and Table 29-7.
• Updated Min and Typ columns of DC16 in
Table 29-3.
• Updated OS10 parameter in Table 29-16.
• Added rows, AD08 and AD09, in Table 29-22.
• Added Figure 29-2.