Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller TQFP 64 (10x10) 16-Bit 32 MHz I/O number 53

331

332

333

334

335

336

337

338

339

340

PIC24FJ128GA310 FAMILY

DS39996F-page 338  2010-2011 Microchip Technology Inc.

U-1 U-1 U-1 U-1 U-1 U-1 U-1 U-1

— — — — — — — —

bit 23 bit 16

R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1 r-1 R/PO-1

WPEND WPCFG WPDIS

BOREN

WDTWIN1 WDTWIN0

SOSCSEL

bit 15 bit 8

R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1 R/PO-1

VBTBOR

WPFP6

(3)

WPFP5 WPFP4 WPFP3 WPFP2 WPFP1 WPFP0

bit 7 bit 0

Legend: PO = Program Once bit r = Reserved bit

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown

bit 23-16 Unimplemented: Read as ‘1’

bit 15 WPEND: Segment Write Protection End Page Select bit

1 = Protected code segment upper boundary is at the last page of program memory; the lower

boundary is the code page specified by WPFP<6:0>

0 = Protected code segment lower boundary is at the bottom of the program memory (000000h); upper

boundary is the code page specified by WPFP<6:0>

bit 14 WPCFG: Configuration Word Code Page Write Protection Select bit

1 = Last page (at the top of program memory) and Flash Configuration Words are not write-protected

(1)

0 = Last page and Flash Configuration Words are write-protected provided WPDIS = ‘0’

bit 13 WPDIS: Segment Write Protection Disable bit

1 = Segmented code protection is disabled

0 = Segmented code protection is enabled; protected segment is defined by the WPEND, WPCFG and

WPFPx Configuration bits

bit 12

BOREN: Brown-out Reset Enable bit

1 = BOR is enabled (all modes except Deep Sleep)

0 = BOR is disabled

bit 11-10 WDTWIN<1:0>: Watchdog Timer Window Width Select bits

11 =25%

10 =37.5%

01 =50%

00 =75%

bit 9 Reserved: Always maintain as ‘1’

bit 8 SOSCSEL: SOSC Selection bit

1 = SOSC circuit is selected

0 = Digital (SCLKI) mode

(2)

bit 7 VBTBOR: VBAT BOR Enable bit

1 =V

BAT BOR is enabled

0 =V

BAT BOR is disabled

Note 1: Regardless of WPCFG status, if WPEND = 1 or if WPFP corresponds to the Configuration Word page, the

Configuration Word page is protected.

2: Ensure that the SCLKI pin is made a digital input while using this configuration (see Tabl e 11 -1).

3: For the 62K devices: PIC24FJ64GA310, PIC24FJ64GA308 and PIC24FJ64GA306, bit 6 should be

maintained as ‘0’.