Datasheet

 2010 Microchip Technology Inc. DS39951C-page 189

PIC24FJ64GA104 FAMILY

bit 5 ADDEN: Address Character Detect bit (bit 8 of received data = 1)

1 = Address Detect mode is enabled. If 9-bit mode is not selected, this does not take effect.

0 = Address Detect mode is disabled

bit 4 RIDLE: Receiver Idle bit (read-only)

1 = Receiver is Idle

0 = Receiver is active

bit 3 PERR: Parity Error Status bit (read-only)

1 = Parity error has been detected for the current character (character at the top of the receive FIFO)

0 = Parity error has not been detected

bit 2 FERR: Framing Error Status bit (read-only)

1 = Framing error has been detected for the current character (character at the top of the receive FIFO)

0 = Framing error has not been detected

bit 1 OERR: Receive Buffer Overrun Error Status bit (clear/read-only)

1 = Receive buffer has overflowed

0 = Receive buffer has not overflowed (clearing a previously set OERR bit (1  0 transition) will reset

the receiver buffer and the RSR to the empty state

bit 0 URXDA: Receive Buffer Data Available bit (read-only)

1 = Receive buffer has data, at least one more character can be read

0 = Receive buffer is empty

Note 1: Value of bit only affects the transmit properties of the module when the IrDA encoder is enabled (IREN = 1).

2: If UARTEN = 1, the peripheral inputs and outputs must be configured to an available RPn pin. See

Section 10.4 “Peripheral Pin Select (PPS)” for more information.