Datasheet

 2010 Microchip Technology Inc. DS39951C-page 271
PIC24FJ64GA104 FAMILY
TABLE 28-6: DC CHARACTERISTICS: POWER-DOWN BASE CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
DC60 0.05 1.0 A-40°C
2.0V
(3)
Base Power-Down Current
(5)
DC60a 0.2 1.0 A+25°C
DC60i 2.0 6.5 A+60°C
DC60b 3.5 12 A+85°C
DC60m 29.9 50 A +125°C
DC60c 0.1 1.0 A-40°C
2.5V
(3)
DC60d 0.4 1.0 A+25°C
DC60j 2.5 15 A+60°C
DC60e 4.2 25 A+85°C
DC60n 36.2 75 A +125°C
DC60f 3.3 9.0 A-40°C
3.3V
(4)
DC60g 3.3 10 A+25°C
DC60k 5.0 20 A+60°C
DC60h 7.0 30 A+85°C
DC60p 39.2 80 A +125°C
DC70c 0.003 0.2 A-40°C
2.5V
(4)
Base Deep Sleep Current
DC70d 0.02 0.2 A+25°C
DC70j 0.2 0.35 A+60°C
DC70e 0.51 1.5 A+85°C
DC70a 6.1 12 A +125°C
DC70f 0.01 0.3 A-40°C
3.3V
(4)
DC70g 0.04 0.3 A+25°C
DC70k 0.2 0.5 A+60°C
DC70h 0.71 2.0 A+85°C
DC70b 7.2 16 A +125°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with the device in Sleep mode (all peripherals and clocks shut down). All I/Os are
configured as inputs and pulled high. WDT, etc., are all switched off, PMSLP bit is clear and the Peripheral
Module Disable (PMD) bits for all unused peripherals are set.
3: On-chip voltage regulator is disabled (DISVREG is tied to V
DD).
4: On-chip voltage regulator is enabled (DISVREG is tied to V
SS). Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.
5: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.