Datasheet

PIC24FJ64GA104 FAMILY
DS39951C-page 270  2010 Microchip Technology Inc.
DC50 0.8 1.0 mA -40°C
2.0V
(3)
FRC (4 MIPS)
DC50a 0.8 1.0 mA +25°C
DC50b 0.8 1.0 mA +85°C
DC50c 0.9 1.1 mA +125°C
DC50d 1.1 1.3 mA -40°C
3.3V
(4)
DC50e 1.1 1.3 mA +25°C
DC50f 1.1 1.3 mA +85°C
DC50g 1.2 1.4 mA +125
°C
DC51 2.4 8.0 A-40°C
2.0V
(3)
LPRC (31 kHz)
DC51a 2.2 8.0 A+25°C
DC51b 7.2 21 A+85°C
DC51c 35 50 A+125°C
DC51d 38 55 A-40°C
3.3V
(4)
DC51e 44 60 A+25°C
DC51f 70 100 A+85°C
DC51g 96 150 A+125
°C
TABLE 28-5: DC CHARACTERISTICS: IDLE CURRENT (IIDLE) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  TA  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Idle Current (I
IDLE)
(2)
Note 1: Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only and
are not tested.
2: Base I
IDLE current is measured with the core off, OSCI driven with external square wave from rail to rail. All I/O
pins are configured as inputs and pulled to V
DD. MCLR = VDD; WDT and FSCM are disabled. No peripheral
modules are operating and all of the Peripheral Module Disable (PMD) bits are set.
3: On-chip voltage regulator is disabled (DISVREG is tied to V
DD).
4: On-chip voltage regulator is enabled (DISVREG is tied to V
SS). Low-Voltage Detect (LVD) and Brown-out Detect
(BOD) are enabled.