Datasheet

 2010-2013 Microchip Technology Inc. DS39881E-page 239
PIC24FJ64GA004 FAMILY
DC62 8 16 A-40°C
2.0V
(3)
RTCC + Timer1 w/32 kHz Crystal:
RTCC, I
TI32
(5)
DC62a 12 16 A+25°C
DC62m 12 16 A+60°C
DC62b 12 16 A+85°C
DC62j 18 23 A +125°C
DC62c 9 16 A-40°C
2.5V
(3)
DC62d 12 16 A+25°C
DC62n 12 16 A+60°C
DC62e 12.5 16 A+85°C
DC62k 20 25 A +125°C
DC62f 10.3 18 A-40°C
3.3V
(4)
DC62g 13.4 18 A+25°C
DC62o 14.0 18 A+60°C
DC62h 14.2 18 A+85°C
DC62l 23 28 A +125°C
DC63 2 — A-40°C
2.0V
(3)
RTCC + Timer1 w/Low-Power
32 kHz Crystal
(SOCSEL<1:0> = 01): RTCC,
I
TI32
(5)
DC63a 2 — A+25°C
DC63b 6 — A+85°C
DC63c 2 — A-40°C
2.5V
(3)
DC63d 2 — A+25°C
DC63e 7 — A+85°C
DC63f 2 — A-40°C
3.3V
(4)
DC63g 3 — A+25°C
DC63h 7 — A+85°C
TABLE 27-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD): PMD Bits are Set, PMSLP Bit is ‘0’
(2)
Note 1: Data in the Typical column is at 3.3V, +25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. WDT, etc., are all switched off.
3: On-chip voltage regulator is disabled (DISVREG tied to VDD).
4: On-chip voltage regulator is enabled (DISVREG tied to V
SS). Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.
5: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.