Datasheet

 2010-2013 Microchip Technology Inc. DS39881E-page 143
PIC24FJ64GA004 FAMILY
To set up the SPIx module for the Enhanced Buffer
Master mode of operation:
1. If using interrupts:
a) Clear the SPIxIF bit in the respective IFSx
register.
b) Set the SPIxIE bit in the respective IECx
register.
c) Write the SPIxIP bits in the respective IPCx
register.
2. Write the desired settings to the SPIxCON1 and
SPIxCON2 registers with the MSTEN bit
(SPIxCON1<5>) = 1.
3. Clear the SPIROV bit (SPIxSTAT<6>).
4. Select Enhanced Buffer mode by setting the
SPIBEN bit (SPIxCON2<0>).
5. Enable SPIx operation by setting the SPIEN bit
(SPIxSTAT<15>).
6. Write the data to be transmitted to the SPIxBUF
register. Transmission (and reception) will start
as soon as data is written to the SPIxBUF
register.
To set up the SPIx module for the Enhanced Buffer
Slave mode of operation:
1. Clear the SPIxBUF register.
2. If using interrupts:
• Clear the SPIxIF bit in the respective IFSx
register.
• Set the SPIxIE bit in the respective IECx
register.
• Write the SPIxIP bits in the respective IPCx
register to set the interrupt priority.
3. Write the desired settings to the SPIxCON1 and
SPIxCON2 registers with the MSTEN bit
(SPIxCON1<5>) = 0.
4. Clear the SMP bit.
5. If the CKE bit is set, then the SSEN bit must be
set, thus enabling the SSx
pin.
6. Clear the SPIROV bit (SPIxSTAT<6>).
7. Select Enhanced Buffer mode by setting the
SPIBEN bit (SPIxCON2<0>).
8. Enable SPIx operation by setting the SPIEN bit
(SPIxSTAT<15>).
FIGURE 15-2: SPIx MODULE BLOCK DIAGRAM (ENHANCED MODE)
Internal Data Bus
SDIx
SDOx
SSx/FSYNCx
SCKx
bit 0
Shift Control
Edge
Select
F
CY
Enable
TransferTransfer
Write SPIxBUFRead SPIxBUF
16
SPIxCON1<1:0>
SPIxCON1<4:2>
Master Clock
Clock
Control
Control
Sync
8-Level FIFO
Receive Buffer
8-Level FIFO
Transmit Buffer
SPIxBUF
SPIxSR
Primary
1:1/4/16/64
Prescaler
Secondary
Prescaler
1:1 to 1:8