Datasheet

 2009 Microchip Technology Inc. DS39897C-page 317
PIC24FJ256GB110 FAMILY
DC62 2.5 7 A-40°C
2.0V
(3)
RTCC + Timer1 w/32 kHz Crystal:
RTCC + I
TI32
(5)
DC62a 2.5 7 A+25°C
DC62m 3.0 7 A+60°C
DC62b 3.0 7 A+85°C
DC62c 2.8 7 A-40°C
2.5V
(3)
DC62d 3.0 7 A+25°C
DC62n 3.0 7 A+60°C
DC62e 3.0 7 A+85°C
DC62f 3.5 10 A-40°C
3.3V
(4)
DC62g 3.5 10 A+25°C
DC62p 4.0 10 A+60°C
DC62h 4.0 10 A+85°C
TABLE 29-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. WDT, etc., are all switched off, PMSLP bit is clear, and the Peripheral Module Disable (PMD)
bits for all unused peripherals are set.
3: On-chip voltage regulator disabled (ENVREG tied to VSS).
4: On-chip voltage regulator enabled (ENVREG tied to V
DD). Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.
5: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.