Datasheet
2009 Microchip Technology Inc. DS39897C-page 3
PIC24FJ256GB110 FAMILY
Power Management:
• On-Chip 2.5V Voltage Regulator
• Switch between Clock Sources in Real Time
• Idle, Sleep and Doze modes with Fast Wake-up and
Two-Speed Start-up
• Run mode: 1 mA/MIPS, 2.0V Typical
• Sleep mode Current Down to 100 nA Typical
• Standby Current with 32 kHz Oscillator: 2.5 A,
2.0V typical
Universal Serial Bus Features:
• USB v2.0 On-The-Go (OTG) Compliant
• Dual Role Capable – can act as either Host or Peripheral
• Low-Speed (1.5 Mb/s) and Full-Speed (12 Mb/s) USB
Operation in Host mode
• Full-Speed USB Operation in Device mode
• High-Precision PLL for USB
• Internal Voltage Boost Assist for USB Bus Voltage
Generation
• Interface for Off-Chip Charge Pump for USB Bus
Voltage Generation
• Supports up to 32 Endpoints (16 bidirectional):
- USB Module can use any RAM location on the
device as USB endpoint buffers
• On-Chip USB Transceiver with On-Chip Voltage Regulator
• Interface for Off-Chip USB Transceiver
• Supports Control, Interrupt, Isochronous and Bulk Transfers
• On-Chip Pull-up and Pull-Down Resistors
High-Performance CPU:
• Modified Harvard Architecture
• Up to 16 MIPS Operation at 32 MHz
• 8 MHz Internal Oscillator
• 17-Bit x 17-Bit Single-Cycle Hardware Multiplier
• 32-Bit by 16-Bit Hardware Divider
• 16 x 16-Bit Working Register Array
• C Compiler Optimized Instruction Set Architecture with
Flexible Addressing modes
• Linear Program Memory Addressing, Up to 12 Mbytes
• Linear Data Memory Addressing, Up to 64 Kbytes
• Two Address Generation Units for Separate Read and
Write Addressing of Data Memory
Analog Features:
• 10-Bit, Up to 16-Channel Analog-to-Digital (A/D)
Converter at 500 ksps:
- Conversions available in Sleep mode
• Three Analog Comparators with Programmable Input/
Output Configuration
• Charge Time Measurement Unit (CTMU)
Device
Pins
Program
Memory (Bytes)
SRAM (Bytes)
Remappable Peripherals
I
2
C™
10-Bit A/D (ch)
Comparators
PMP/PSP
JTAG
CTMU
USBOTG
Remappable
Pins
Timers 16-Bit
Capture Input
Compare/
PWM Output
UART w/IrDA
®
SPI
PIC24FJ64GB106 64 64K 16K 29 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ128GB106 64 128K 16K 29 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ192GB106 64 192K 16K 29 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ256GB106 64 256K 16K 29 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ64GB108 80 64K 16K 40 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ128GB108 80 128K 16K 40 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ192GB108 80 192K 16K 40 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ256GB108 80 256K 16K 40 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ64GB110 100 64K 16K 44 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ128GB110 100 128K 16K 44 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ192GB110 100 192K 16K 44 5 9 9 4 3 3 16 3 Y Y Y Y
PIC24FJ256GB110 100 256K 16K 44 5 9 9 4 3 3 16 3 Y Y Y Y
64/80/100-Pin, 16-Bit Flash Microcontrollers
with USB On-The-Go (OTG)