Datasheet

 2009 Microchip Technology Inc. DS39897C-page 227

PIC24FJ256GB110 FAMILY

U-0 U-0 U-0 U-0 U-0 U-0 U-0 U-0

— — — — — — — —

bit 15 bit 8

R-x, HSC R-x, HSC R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0

JSTATE SE0 TOKBUSY USBRST HOSTEN RESUME PPBRST SOFEN

bit 7 bit 0

Legend: U = Unimplemented bit, read as ‘0’

R = Readable bit W = Writable bit HSC = Hardware Settable/Clearable bit

-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown

bit 15-8 Unimplemented: Read as ‘0’

bit 7 JSTATE: Live Differential Receiver J State Flag bit

1 = J state (differential ‘0’ in low speed, differential ‘1’ in full speed) detected on the USB

0 = No J state detected

bit 6 SE0: Live Single-Ended Zero Flag bit

1 = Single-ended zero active on the USB bus

0 = No single-ended zero detected

bit 5 TOKBUSY: Token Busy Status bit

1 = Token being executed by the USB module in On-The-Go state

0 = No token being executed

bit 4 USBRST: Module Reset bit

1 = USB Reset has been generated; for software Reset, application must set this bit for 50 ms, then

clear it

0 = USB Reset terminated

bit 3 HOSTEN: Host Mode Enable bit

1 = USB host capability enabled; pull-downs on D+ and D- are activated in hardware

0 = USB host capability disabled

bit 2 RESUME: Resume Signaling Enable bit

1 = Resume signaling activated; software must set bit for 10 ms and then clear to enable remote wake-up

0 = Resume signaling disabled

bit 1 PPBRST: Ping-Pong Buffers Reset bit

1 = Reset all Ping-Pong Buffer Pointers to the EVEN BD banks

0 = Ping-Pong Buffer Pointers not reset

bit 0 SOFEN: Start-Of-Frame Enable bit

1 = Start-Of-Frame token sent every one 1 millisecond

0 = Start-Of-Frame token disabled